A perfect way to use a flat mopping system
1. USE THE RIGHT AMOUNT TO WATER
Do not over wet your floor & refills. Usually the correct amount of water is 100 ml-125 ml per 40 cm-45 cm mop refill
2. PLACE THE MICROFIBER MOP ON THE FLOOR FIRST
Gently place both the frame & the handle in the correct position on top of the refill
3. START MOPPING AT THE FURTHEST POINT FROM YOUR EXIT
Always use 'Caution Wet Floor' safety signs when needed
4. MOP IN A FIGURE 8 MOTION, NOT BACK AND FORTH
Do not mop back and forth. Instead, mop in a figure eight motion
5. CHANGE THE MOP REFILLS AFTER CLEANING EACH ROOM
Regularly change mops when changing zones or areas so that cross contamination is prevented
6. WHEN YOU'VE FINISHED MOPPING, REMOVE THE FRAME FROM THE MOP
You may want to do this with gloves on. Ensure the direct mop refills are laundered separately.
7. BEFORE OPENING THE AREA TO TRAFFIC, ALLOW THE AREA TO DRY
If you are using a high quality microfiber mop and the correct amount of water, it should not take long for the floor to dry